Opening & Daily Closing Procedures C717/C709

Heat Treatment & Helpful Tips

Prepare a small amount approved sanitizer. Container or spray bottle
Sanitize door Spout(s) and bottom draw valves for 1 minute. Install red design rings
When ready to resume normal operation, touch the auto snowflake symbol. When the unit cycles off the product in the freezing cylinder will be ready to serve.
Place all cleaned and sanitized parts back in place. *Note the mix feed tube hole down
Use a clean, sanitized towel, wipe down the freezer door front panel and area around the bottom of the freezer door, and any other areas that demonstrate a buildup of either moisture or soft serve mix.

Install the clean and sanitized Flavor Burst Assembly to the Taylor freezer
Check the operation
Hold a cup under the Flavor Burst spout. Push the sanitizer button on the Keypad or Color Touch Panel to sanitize the assembly.

Remove drip pan(s), front drip tray, splash shield and air orifice(s), red design caps and place on a clean dry surface to air dry overnight
Remove: Mix feed tube(s) – Air orifice(s) – Agitator(s) – Hopper cover(s) clean and sanitize, put back in place. Note: Mix Feed tube side hole in the up position
Fill Mix level between the low high marks on the agitator
Be sure the agitator(s) are installed, and the power switch is on, and are in either the Auto/Snowflake or Standby/Rain Drop mode or the unit will not have a successful heat treat cycle.
Sanitize door Spout(s) and bottom draw valves for 1 minute.
Auto Heat Cycle Good to go…. Manual Heat Cycle touch the Sun/Heat treatment symbol
Use a clean, sanitized towel, wipe down the freezer door front panel and area around the bottom of the freezer door, and any other areas that demonstrate a buildup of either moisture or soft serve mix.

Hold a cup under the Flavor Burst spout. Push the sanitizer button on the Keypad or Color Touch Panel to sanitize the assembly.
Remove the Flavor Burst assembly, clean and sanitize let air dry
Cap the injector syrup tube